Description
High-quality replacement for the T4 Syncro propshaft centring bushes.
Reference number
191521137 (no spare part is actually intended for this position on the T4 Syncro propshaft)
These pilot bearings ensure the centring of the propshaft on the 16 mm pins of the bevel gear output flange and the rear differential input shaft. The centring bushes are actually very durable and subject to little wear, but can be easily damaged by improper disassembly (e.g. the propshaft tube is bent rather than pulled straight off the centring pin during removal). When overhauling the propshaft, it is recommended to replace the centring bushes to ensure smooth and low-vibration running of the shaft. Often the shaft seal is also damaged, resulting in moisture ingress and corrosion of the precision-ground surface of the centring pins.
Caution during assembly: The bushes have no end stop in the propshaft tubes and must be pressed in to a specific protrusion. The bushes cannot be removed non-destructively, which is why you must work very precisely when pressing them in. It is best to measure the protrusion before removing the old bushes. We have determined the following values on various propshafts:
Front section (centring at the final drive): 15.0 mm
Rear section (centring at the rear differential): 24.0 mm












Reviews
There are no reviews yet.