Front Haldex differential bracket

189,90 €

Differential bracket for installing 1st generation Haldex differentials in the T4 Syncro, suitable for all model years.

Delivery time: 2–4 working days

1 in stock

SKU: 30-1027 Category:

Description

Front bracket for using Haldex Generation 1 rear differentials in the T4 Syncro.

Previously, a DIY solution was always required for the front bracket during a Haldex conversion in the T4 Syncro. Due to space constraints caused by the Haldex control unit near the front differential bracket, the bracket from the 02D differential cannot be used. Notching the original T4 bracket near the Haldex ECU weakens the structure, which can cause the brackets to break under heavy loads, usually resulting in an expensive propshaft repair.

This bracket was specifically developed to install 1st generation Haldex differentials in the T4 Syncro. The available installation space is utilised and the mounting principle of the original bracket is adopted. The bracket uses custom-made PU bushings with a hardness of Shore 70A, which corresponds to the original rubber mounts of the T4 rear differential. This results in improved durability without increasing the transmission of vibrations to the body. The bracket still allows for Haldex oil and filter changes while installed.

The geometry of the bracket was chosen so that the Haldex differential sits at standard height. This allows the drivetrain to be run at standard height or lowered using variant 1 or 2. IMPORTANT: Please specify in the order notes if the differential is being mounted with a lowering kit, as the correct bolt is included and the bolt length depends on the lowering variant.

Both the bracket and all other steel parts feature a zinc flake coating. We nevertheless recommend additional preservation of the areas around the contact points between the aluminium housing and the bracket to prevent contact corrosion in the long term. Scope of delivery includes the bracket, 2x PU bushings, 1x spacer sleeve, 1x plate, 3x bolts for bracket to differential housing, and 1x bolt for bracket to differential carrier.

The following torque specifications must be observed during installation: all bolts 60 Nm.

Additional information

Weight 1,66 kg

Product safety

Manufacturer information

allradbus – Martin Günther
Oststr. 1
99427 Weimar
Deutschland
info@allradbus.com
http://www.allradbus.com

Safety instructions

Installation only by competent persons or a specialist workshop. Observe the vehicle manufacturer's installation specifications and tightening torques. Check the part for damage before installation.

Reviews

There are no reviews yet.

Be the first to review “Front Haldex differential bracket”

Your email address will not be published. Required fields are marked *